Identify a Gas Water Heater Not Heating

Posted by on May 20, 2015 in Gas Water Heater Repair Portland, Water Heater Repair Portland Oregon

A overwhelming majority of the water heaters Water Heater Repair Portland receives repair requests for are gas water heaters. These are most certainly the most favored type. Listed here are a number of self diagnostic steps one can look at if the gas water heater is just not heating water in any way.

How to Self Diagnose a Portland Gas Water Heater Repair

This will likely appear evident, nonetheless verify to guarantee the gas to the water heater is switched on. Move the gas control knob to PILOT to stop the burner from igniting while looking within. Take off the metal cover at the lower part of the water heater and take a look to check if the burner along with the pilot light are ignited.

If the water heater’s pilot light has gone out, abide by the directions on the storage tank to relight it (we have the common measures to achieve this stated below). There does exist a chance that the gas inlet valve is shut to some extent or entirely. If that is the fact, simply turn the handle parallel to the line and ignite the pilot. If the pilot continue to not ignite, then the concern may perhaps be with the thermocouple. A good number of current water heaters possess a glow plug or spark igniter rather than a pilot. Check out the owner’s info for a reference point.Gas Water Heater Repair Portland

If the burner is not on, replace the cover and make certain the thermostat is establish around 120 degrees F. If it is not, correct it, run on a hot water faucet in close proximity to the water heater, and after that wait around a little bit to check if the water heater burner ignites. If it doesn’t ignite, keep the hot water running and try out decreasing and then increasing the temperature setting on the dial until eventually the burner ignites.

In the event that the burner ignites, replace the cover and switch the thermostat once again to a suitable setting. If the burner will not ignite, allow us to examine the water heater. The heater’s thermostat may very well be malfunctioning. A thermostat switch should really be completed by us.

Do you smell gas? If a smell much like garlic is observed, switch the gas valve control to the OFF placement. Hang on and check if the gas odor is gone prior to relighting the pilot. If it does not pass, without delay switch off the gas supply valve, air out the area as best as is possible and phone the gas utility company.

Pilot Light Doesn’t Stay Lit

Attempt to relight the water heater initially. In general terms, move the water heater’s gas valve to the OFF status then to the PILOT placement. Push the pilot button down to light it, and then hang on until a status light indicates the dial may be changed from PILOT to ON.

If perhaps the pilot light continues going out, possibly the orifices may very well be unclean and blocked, that may make the flame too tiny to remain lit. Verify to be sure there is no evident dirt and debris clogging it.

In cases where everything seems clean, the situation might be with the thermocouple. This is the piece that runs from the temperature control directly into the flame of a pilot light and facilitates the main burner fire up as soon as the water temperature has moved too low. The pilot light could possibly be impacted if the thermocouple is flawed or fails to come into contact with the pilot flame. Various people might feel safe changing a thermocouple, but Gas Water Heater Repair Portland would rather you call us to help.

Decreased gas pressure or a not working gas control valve may also bring about a pilot light to go out often. Call us if you believe this is the situation.